Concrete Structural Design for Industrial Projects
Introduction
This Discovery Tools training course ” Concrete Structural Design for Industrial Projects ” will fill the gap between the academic knowledge and the professionalism for industrial project design in general, and specifically for Oil & Gas and power generation projects. Reinforced concrete structures are widely used in the industrial sector, especially in the onshore Oil & Gas fields. In industrial projects, the structure design applications are different than normal housing projects taught in educational / engineering institutions.
The basis of design for concrete structure for strength, serviceability, and robustness is considered in the training course. ACI, BS, UBC, and ASCE codes will also be covered to enable the participants to choose a suitable design method to serve business safety and operability. The probability of failure, specifically in ACI and BS, will be discussed, and the key steps in design and review design will be illustrated. Moreover, the attention will be paid for the practical solution of field problems and challenges considering the secondary loads such as wind loads and seismic forces as well.
This training course will highlight:
- Review of different codes and standards
- The importance of construction and maintenance
- The dynamic analysis and design for concrete in the industrial plant
- Industry practice in the structure design
- Integration between different disciplines in designing
- Effect of sustainable design to enhance project investment life cycle
Course Objectives
By the end of this training course, participants will be able to:
- An overview of modern and effective procedures for the design of reinforced concrete structures in the Oil & Gas industry
- Knowledge on calculation for reinforced concrete elements used in the Oil & Gas industry
- Increase the knowledge and assist in using new tools for designing and reviewing the design for a new project or modify the existing one
- Knowledge on the design of foundation under all types of vibrating equipment, and the blast design of buildings
- An illustration of real design issues that may assist the designer in providing the concrete structure that is safe, economical and constructible
- The rule of thumb to check the concrete design with an associated checklist
Approved Certificate from 
Training Plan Please Click Here
This training course will be held in ( Istanbul / Sharm El Sheikh / Malaysia / Dubai / Cairo / Alexandria / London / Austria / Amsterdam )
For Registration and Further Information about Training Course Content, Please Contact Us
